Vacuum cleaner should be regularly checked and maintained to keep it working efficiently and properly. Just follow these simple steps to maintain your cordless vacuum cleaner at home as it can save money and time.
Remember to unplug your vacuum cleaner before maintenance. A vacuum cleaner may turn on unexpectedly and it can injure you while you are working on it. Check the vacuum cleaner bag. The best cordless stick vacuum cleaner will not work well if the bag is full. Look for a line on the bag and determine how full it is. If it is 2/3 full, replace the vacuum bag. You should read the directions to make sure you are using the correct bag size and type for your machine. For bagless models, check and empty the tray or pin frequently.Open and clean the brush roll or also called the beater bar. Remove the bottom plate. This cover may have clips or latches, or it may have a couple of screws holding it in place. Thenremove the brush roll. Generally, it will pull out of a slot on either end, then slide out from under the belt. Use scissors or just your fingers to clean the brushes. They don't need to be spotless, but you should remove any hair or string that is wrapped around the brush. Pay special attention to the ends near the bearings and to the area around where the belt engages.Clean and lubricate the bearings on the brush roll. Use your fingers to spin the brush roll on its axle to check if it spins freely or not. If not, you must clean out and lubricate the bearings thoroughly. Replace it if it seems not to work well. Before you take the bearings out, notice which way they went so you can put them back in correctly.Check the belt. If it is worn, you should replace it. Pull on the belt with your fingers and compare with the new one. The good belt should be taut. Otherwise, if the belt is stretched out or narrower than the new one, replace it. As recommendation, you should replace the belt every 6 months to 1 year depending on the frequency of using handheld cordless vacuum cleaner. Remove any large accumulations of debris from the air passages and the brush roll housing.Put the brush roll back. Put the brush roll through the belt. Make sure the belt is still over both the brush roll and the drive shaft. Then put the cover plates back.Check the filters on the vacuum cleaner. Many newer model vacuums have filters on the exhaust air to catch particles that remain in it. Make sure that you read the manual and clean or replace it periodically. If the filter makes of foam or plastic, you can wash it. Please dry it before put it back in the vacuum cleaner. If the filter make of paper or fabric, you can shake or pound out the debris before replacement.
In short, those tips can be helpful for you if your vacuum cleaner does not work properly. You can refer them to have a first look at your vacuum cleaner as it may help you to fix and maintain it periodically.